Timeguard MLWTS User Manual

Installation & Operating Instructions150W Multi PIR Twin Spot LightCat No. MLBTS – Black Cat No. MLWTS – WhiteZerofour – May 2013

PROBLEM• PIR sensor will not operate at all.• The PIR sensor will not operate at night.• Unit activates during the daytime• PIR coverage is poor

Place this edge against wall and use diagram to estimate incoming cable length75mm (3")25mm (1")INCOMING WIRE TEMPLATEUse this diagram to e

Zerofour – May 201367.058.311 (issue 3).Timeguard Limited. Victory Park, 400 Edgware Road, London NW2 6NDSales Office: 020 8452 1112or email csc@timeg

LesssensitiveMoresensitiveTOP VIEW200ºSIDE VIEW12m2.5mA CBD

E GF HLens MaskRestrict long detection Restrict short detectionRestrict RHS detection Restrict LHS detectionDusk/DawnTimeOverride/Holiday Mode

SECTION ONEGENERAL INFORMATIONThe unit utilises passive infrared technology to detect heat radiation of moving human bodies. Upon detection, the lamp

SECTION THREEINSTALLATIONAfter choosing a suitable location (see previous section) install the unit as follows:Remove the wiring box cover by unscrewi

CONNECTION DIAGRAMMains SupplyIsolation SwitchSECTION FOUROPERATION AND TESTINGWALK TEST PROCEDUREThe sensor will rotate from left to right, and tilt

TEST MODE – 3 LEDS VISIBLEThe lamp will now illuminate for approximately 5 seconds every time movement is detected.Walk across the detection area appr

Manual Override Mode is indicated by the permanent illumination of a single red LED in the top of the sensor head. To switch the unit back into Auto

SECTION SIXTROUBLESHOOTING GUIDEPROBLEM• Lamp stays ON all the time at night.• PIR keeps activating for no reason/at random.SOLUTIONThe unit may be