Art. Nr. 202 0 050Art. Nr. 202 0 0001103000311 © 11.08 Theben HTSPresence detectorECO-IR 180AECO-IR 360AFGBDEINLBedienungsanleitung 2Notice d´utilisa
505. Start-up5.1 SettingsSet the unit as shown on the rear of the disassembled sensor head. Note the setting guidelines in the following tables for de
51 Switch-off time delay «Light»Set the desired minimum switch-off delay time for the «Light» switching contact on the potentiometer.Trans
525.3 Behaviour on switching onAfter you have dened the settings, connect the upper part to the power section. Ensure that the labelling is aligned o
53The service phase is completed automatically after 10 minutes. Repeat the setting procedure if it is necessary to modify one of the three variables.
546.Technicalspecications*) Use of T5-FL: When using T5-FL lamps with a comparable wattage, the same number of electronic ballasts may be connected
55GBCommon power module ECO-IR 540B2Nominal voltage 230V± 10%, 50HzSwitching contact A«Light»Contact design 230V± 10%Max switching capacity 1400VAMax.
567. Warranty declarationTheben HTS presence detectors are manufactured and quality-tested with the utmost care using state-of-the-art technologies
57GB8. TroubleshootingFault Cause RemedyLighting on after the detector is connected.Both outputs are closed for 90 s after the detector has been conne
58Subject to change without prior notice. Errors and omissions excepted.Dimensions ECO-IR 180A5611470705646,3358048704585
59Declaration of CE conformityThis device complies with the protection regulations of the EMC directive 2004/108/EC and of the Low Voltage directive 2
42 EnglishInstallation manualPresence detector ECO-IR 180AECO-IR 360ATable of contents1. Safety . . . . . . . . . . . . . . . . . . . . . . . . . .
60Theben AGHohenbergstrasse 32, DE-72401 HaigerlochTel. +49 (0) 74 74 692 - 0Fax +49 (0) 74 74 692 - 150HotlineTel. +49 (0) 74 74 692 - 369Fax +49 (
43Thank you for choosing a Theben HTS presence detector and putting your trust in us.1. SafetyDANGER !Any work on electrical systems must exc
442. Function and performance characteristics2.1 Presence detectionHigh-sensitivity PIR sensors and an intelligent lens system provide complete covera
45When using suspended lighting, we recommend that you integrate the de-tector directly in the lamps or provide a sufcient lateral clearance. When us
463. Detection Range3.1 Detection Range ECO-IR 180A for wall mountingThe recommended mounting height is 2,2m. Mounting the device in the hei
47ECO-IR 180A: ECO-IR 360A:GBo2,2 m1 2 356 7 8040213o
484. Mounting and connecting the device4.1 Type of mounting Both ECO-IR models must be mounted in housings (surface-mounted or con-cealed installation
494.4 Stepping switch/time switchesThe ECO-IR must not be used to trigger stepping switches. The unit may only be connected in parallel to time switch
Comments to this Manuals