Timeguard DSS User Manual Page 1

Installation & Operating Instructions2 Wire Electronic Time Delay SwitchCat No. DS13 Wire Electronic Time Delay SwitchCat No. DS22 Wire Slave Sw

9 10Zerofour – May 20136. Specifications – DS1.i Conforms to Directives: 73/23/EEC & 89/336/EECii Permissible Loads: Filament lamps – 1.5kW

10 11DS2 – Instructions for Installation and UseIf you have a DS1 working alone or with one or more DSS’s please refer to separate instructions on pa

11 12Delay time adjuster.Time range selectorFig 2 – Rear of DS22. Installation.IF IN DOUBT CONSULT AN ELECTRICIAN. SWITCH OFF MAINS ELECTRICITY. Set

12 13Make sure that the wallbox is earthed if it is metal. Ensure that all three terminals are tight before screwing the two plate fixing screws suppl

13 144. Operation.Whenever light or appliance operation is required press the push button and the light(s)/appliance(s) under control will remain ON

143 Year GuaranteeIn the unlikely event of this product becoming faulty due to defective material or manufacture within 3 years of the date of purchas

9Zerofour – May 2013Timeguard Limited. Victory Park, 400 Edgware Road, London NW2 6NDSales Offi ce: 020 8452 1112or email [email protected] a produc

1 2DS1/DSS – Instructions for Installation and UseIf you have a DS2 please refer to separate instructions on page 10.Tough flame retardant polycarbona

2 3Delay time adjuster – centre scale gives approximately 5 minutes (linear scale).Fig 2a – Rear of DS1Fig 2b – Rear of DSS

3 42a. Installation (Replacement of Single ON/OFF Switches Only).FOR INSTALLATION OF DS1 & DSS’s IN 2 WAY AND INTERMEDIATE SWITCHING CONFIGURATION

4 5If only one DSS is required then connect the mains supply live (L) to LIN on the DSS and leave the SLAVE connection formerly going to the second DS

5 6In keeping with BS schematic code wires shown in direct cross over (i.e. +) are not connected electrically.Fig 4 – Strapping Cable & One Interm

6 7Fig 6 – Replacement Delay Switches fitted to circuit shown in fig. 4Fig 7 – Replacement Delay Switches fitted to circuit shown in fig. 5A DS1 and t

7 8Fig 8 – 2 Way Switching – Strapping CableFig 9 – 2 Way Switching – Remote Live AccessFurther DSS’s can be added to replace any further intermediate

8Fig 10 – Replacement Delay Switches fitted to circuit shown in fig. 8Fig 11 – Replacement Delay Switches fitted to circuit shown in fig. 9In keeping