1103023503 / 09.08 © Theben HTSArt. Nr. 201 0 090Presence detectorcompact passageFGBDEINLBedienungsanleitung 2Notice d´utilisation 22Installation ma
504.3 Behaviour on switching onWhenever the sensor module is plugged onto the power module or the unit is energised, the detector goes through tree ph
515. Additional wiring examples5.1 Master-Slave parallel circuit operationMultiple detectors control one lighting groupOnly the master switches the li
525.2 Master-Master parallel circuit operationMultiple masters control multiple lighting groupsOne master with individual brightness measurement per l
535.3 Parallel circuit operation with external staircase lighting timerDirectly connect the switching contacts of multiple detectors in parallel.Set t
546. Test modeThe test mode serves to check the presence detection and the wiring (Master-Slave parallel circuit operation).6.1 Setting the test mode
55Sensor module compact passageDetection range horizontal vertical360°160°Recommended mounting height 2,0 - 3,5mMaximum range 30 x 4 m (Mh. 2,5m)30
56*) Use of T5-FL: When using T5-FL lamps with a comparable wattage, the same number of electronic ballasts may be connected to the detector’s switchi
578. Warranty declarationTheben HTS presence detectors are manufactured and quality-tested with the ut-most care using state-of-the-art technologies.
589. TroubleshootingFault CauseLighting does not switch on or switches off in case of presence and darkness Lux value setting is too low; Detector is
59Subject to change without prior notice. Errors and omissions excepted.GBDimensions compact passage66904676∅26,544102,5484040,57563
42 EnglishInstallation manualPresence detectorcompact passageTable of contents1. Safety ...392. Funct
60Theben AGHohenbergstrasse 32, DE-72401 HaigerlochTel. +49 (0) 74 74 692 - 0Fax +49 (0) 74 74 692 - 150HotlineTel. +49 (0) 74 74 692 - 369Fax +49 (
43Thank you for purchasing an Theben HTS presence detector and putting your trust in us.1. SafetyDANGER !Any work on electrical systems must exclusive
442. Function and performance characteristicsThe presence detector compact passage is used for a comfortable and efci-ent light as well as HVAC contr
453. Fitting and connection3.1 Presence detectionThe ideal mounting height is 2,0 - 3,5m. The sensitivity of the detector de-creases with increasing m
463.2 Light measurementThe detector measures articial light and daylight reected directly bene-ath the detector (beam width approx. ± 30°).The m
474. Start-upThe detectors are supplied ready for operation with a factory setting of recom-mended standard values.The QuickSet plus service remote co
48 Switch-off delay timeTransfer areas approx. 5min.In the range between 2 - 15min the switch-off delay varies according to its self-learning behavi
494.2 Settings for switching output B «Presence» Switch-off delay time for presenceThe pre-set values remain unchanged (no self-learning effect). S
Comments to this Manuals